Para rubber tree

Hevea brasiliensis, the Pará rubber tree, sharinga tree, seringueira, or, most commonly, the rubber tree or rubber plant, is a tree belonging to the family Euphorbiaceae. It is the most economically important member of the genus Hevea because the milky latex extracted from the tree is the primary source of natural rubber. H. brasiliensis is a tall deciduous tree growing to a height of up to 43 m (141 ft) in the wild, but cultivated trees are usually much smaller because drawing off the latex restricts the growth of the tree. The trunk is cylindrical and may have a swollen, bottle-shaped base. The bark is some shade of brown, and the inner bark oozes latex when damaged. The leaves have three leaflets and are spirally arranged. The inflorescence include separate male and female flowers. The flowers are pungent, creamy-yellow and have no petals. The fruit is a capsule that contains three large seeds; it opens explosively when ripe. In the wild, the tree can reach a height of up to 140 feet (43 m). The white or yellow latex occurs in latex vessels in the bark, mostly outside the phloem. These vessels spiral up the tree in a right-handed helix which forms an angle of about 30 degrees with the horizontal, and can grow as high as 45 ft. In plantations, the trees are generally smaller for two reasons: 1) trees grow more slowly when they are tapped for latex, and 2) trees are generally cut down after only 30 years, because latex production declines as trees age, and they are no longer economically productive. The tree requires a tropical or subtropical climate with a minimum of about 1,200 mm per year of rainfall, and no frost. If frost does occur, the results can be disastrous for production. One frost can cause the rubber from an entire plantation to become brittle and break once it has been refined.' The natural rubber tree takes between seven and ten years to deliver the first harvest. Harvesters make incisions across the latex vessels, just deep enough to tap the vessels without harming the tree's growth, and the latex is collected in small buckets. This process is known as rubber tapping. Latex production is highly variable from tree to tree and across clone types. As latex production declines with age, rubber trees are generally felled when they reach the age of 25 to 30 years. The earlier practice was to burn the trees, but in recent decades, the wood has been harvested for furniture making. The South American rubber tree grew only in the Amazon rainforest, and increasing demand and the discovery of the vulcanization procedure in 1839 led to the rubber boom in that region, enriching the cities of Belém, Santarém, Manaus and Iquitos, Peru, of 1840 to 1913. In Brazil, the initial name of the plant was pará rubber tree. The name of the tree derives from Grão-Pará and Rio Negro or only Grão-Pará (Great-Pará), the largest Brazilian province until 1850, the capital of which is Belém, where most of the fluid, also called latex, was extracted and exported. In Peru, in addition to the hispanic-speaking countries of the Amazon region, the name given was árbol del caucho, with the fluid extracted called caucho. These trees were used to obtain rubber by the natives who inhabited its geographical distribution. The Olmec people of Mesoamerica extracted and produced similar forms of primitive rubber from analogous latex-producing trees such as Castilla elastica as early as 3,600 years ago. The rubber was used, among other things, to make the balls used in the Mesoamerican ballgame. Early attempts were made in 1873 to grow H. brasilensis outside Brazil. After some effort, 12 seedlings were germinated at the Royal Botanic Gardens, Kew. These were sent to India for cultivation, but died. A second attempt was then made, some 70,000 seeds being smuggled to Kew in 1875, by Henry Wickham, in the service of the British Empire.:55 About four percent of these germinated, and in 1876, about 2,000 seedlings were sent, in Wardian cases, to Ceylon (modern day Sri Lanka) and 22 were sent to the Botanic Gardens in Singapore. Once established outside its native country, rubber was extensively propagated in the British colonies. Rubber trees were brought to the botanical gardens at Buitenzorg, Java, in 1883. By 1898, a rubber plantation had been established in Malaya, with imported Chinese field workers being the dominant work force in rubber production in the early 20th-century. Today, most rubber tree plantations are in South and Southeast Asia, the top rubber producing countries in 2011 being Thailand, Indonesia, Malaysia, India and Vietnam. The cultivation of the tree in South America (Amazon) ended early in the 20th century because of blight. The blight, called South American leaf blight, is caused by the ascomycetes, Microcyclus ulei or Pseudocercospora ulei.