Passive optical network

A passive optical network (PON) is a telecommunications technology used to provide fiber to the end consumer, both domestic and commercial. A PON's distinguishing feature is that it implements a point-to-multipoint architecture, in which unpowered fiber optic splitters are used to enable a single optical fiber to serve multiple end-points. The end-points are often individual customers, rather than commercial. A PON does not have to provision individual fibers between the hub and customer. Passive optical networks are often referred to as the 'last mile' between an ISP and customer. A passive optical network (PON) is a telecommunications technology used to provide fiber to the end consumer, both domestic and commercial. A PON's distinguishing feature is that it implements a point-to-multipoint architecture, in which unpowered fiber optic splitters are used to enable a single optical fiber to serve multiple end-points. The end-points are often individual customers, rather than commercial. A PON does not have to provision individual fibers between the hub and customer. Passive optical networks are often referred to as the 'last mile' between an ISP and customer. A PON consists of an optical line terminal (OLT) at the service provider's central office (hub) and a number of optical network units (ONUs) or optical network terminals (ONTs), near end users. A PON reduces the amount of fiber and central office equipment required compared with point-to-point architectures. A passive optical network is a form of fiber-optic access network. In most cases, downstream signals are broadcast to all premises sharing multiple fibers. Encryption can prevent eavesdropping. Upstream signals are combined using a multiple access protocol, usually time division multiple access (TDMA). Two major standard groups, the Institute of Electrical and Electronics Engineers (IEEE) and the Telecommunication Standardization Sector of the International Telecommunication Union (ITU-T), develop standards along with a number of other industry organizations.The Society of Cable Telecommunications Engineers (SCTE) also specified radio frequency over glass for carrying signals over a passive optical network. Starting in 1995, work on fiber to the home architectures was done by the Full Service Access Network (FSAN) working group, formed by major telecommunications service providers and system vendors. The International Telecommunications Union (ITU) did further work, and standardized on two generations of PON. The older ITU-T G.983 standard was based on Asynchronous Transfer Mode (ATM), and has therefore been referred to as APON (ATM PON). Further improvements to the original APON standard – as well as the gradual falling out of favor of ATM as a protocol – led to the full, final version of ITU-T G.983 being referred to more often as broadband PON, or BPON. A typical APON/BPON provides 622 megabits per second (Mbit/s) (OC-12) of downstream bandwidth and 155 Mbit/s (OC-3) of upstream traffic, although the standard accommodates higher rates. The ITU-T G.984 Gigabit-capable Passive Optical Networks (GPON) standard represented an increase, compared to BPON, in both the total bandwidth and bandwidth efficiency through the use of larger, variable-length packets. Again, the standards permit several choices of bit rate, but the industry has converged on 2.488 gigabits per second (Gbit/s) of downstream bandwidth, and 1.244 Gbit/s of upstream bandwidth. GPON Encapsulation Method (GEM) allows very efficient packaging of user traffic with frame segmentation. By mid-2008, Verizon had installed over 800,000 lines. British Telecom, BSNL, Saudi Telecom Company, Etisalat, and AT&T were in advanced trials in Britain, India, Saudi Arabia, the UAE, and the US, respectively. GPON networks have now been deployed in numerous networks across the globe, and the trends indicate higher growth in GPON than other PON technologies.