Hydraulic mining

Hydraulic mining is a form of mining that uses high-pressure jets of water to dislodge rock material or move sediment. In the placer mining of gold or tin, the resulting water-sediment slurry is directed through sluice boxes to remove the gold. It is also used in mining kaolin and coal. Hydraulic mining is a form of mining that uses high-pressure jets of water to dislodge rock material or move sediment. In the placer mining of gold or tin, the resulting water-sediment slurry is directed through sluice boxes to remove the gold. It is also used in mining kaolin and coal. Hydraulic mining originated out of ancient Roman techniques that used water to excavate soft underground deposits. Its modern form, using pressurized water jets produced by a nozzle called a 'monitor', came about in the 1850s during the California Gold Rush in the United States. Though successful in extracting gold-rich minerals, the widespread use of the process resulted in extensive environmental damage, such as increased flooding and erosion, and sediment blocking waterways and covering over farm fields. These problems led to its legal regulation. Hydraulic mining has since been used in various forms around the world. Hydraulic mining had its precursor in the practice of ground sluicing, a development of which is also known as 'hushing', in which surface streams of water were diverted so as to erode gold-bearing gravels. This was originally used in the Roman empire in the first centuries AD and BC, and expanded throughout the empire wherever alluvial deposits occurred. The Romans used ground sluicing to remove overburden and the gold-bearing debris in Las Médulas of Spain, and Dolaucothi in Britain. The method was also used in Elizabethan England and Wales (and rarely, Scotland) for developing lead, tin and copper mines. Water was used on a large scale by Roman engineers in the first centuries BC and AD when the Roman empire was expanding rapidly in Europe. Using a process later known as hushing, the Romans stored a large volume of water in a reservoir immediately above the area to be mined; the water was then quickly released. The resulting wave of water removed overburden and exposed bedrock. Gold veins in the bedrock were then worked using a number of techniques, and water power was used again to remove debris. The remains at Las Médulas and in surrounding areas show badland scenery on a gigantic scale owing to hydraulicking of the rich alluvial gold deposits. Las Médulas is now a UNESCO World Heritage site. The site shows the remains of at least seven large aqueducts of up to 30 miles (48 km) in length feeding large supplies of water into the site. The gold-mining operations were described in vivid terms by Pliny the Elder in his Naturalis Historia published in the first century AD. Pliny was a procurator in Hispania Terraconensis in the 70s AD and must have witnessed for himself the operations. The use of hushing has been confirmed by field survey and archaeology at Dolaucothi in South Wales, the only known Roman gold mine in Britain. The modern form of hydraulic mining, using jets of water directed under very high pressure through hoses and nozzles at gold-bearing upland paleogravels, was first used by Edward Matteson near Nevada City, California in 1853 during the California Gold Rush. Matteson used canvas hose which was later replaced with crinoline hose by the 1860s. In California, hydraulic mining often brought water from higher locations for long distances to holding ponds several hundred feet above the area to be mined. California hydraulic mining exploited gravel deposits, making it a form of placer mining. Early placer miners in California discovered that the more gravel they could process, the more gold they were likely to find. Instead of working with pans, sluice boxes, long toms, and rockers, miners collaborated to find ways to process larger quantities of gravel more rapidly. Hydraulic mining became the largest-scale, and most devastating, form of placer mining. Water was redirected into an ever-narrowing channel, through a large canvas hose, and out through a giant iron nozzle, called a 'monitor'. The extremely high pressure stream was used to wash entire hillsides through enormous sluices. By the early 1860s, while hydraulic mining was at its height, small-scale placer mining had largely exhausted the rich surface placers, and the mining industry turned to hard rock (called quartz mining in California) or hydraulic mining, which required larger organizations and much more capital. By the mid-1880s, it is estimated that 11 million ounces of gold (worth approximately US$7.5 billion at mid-2006 prices) had been recovered by hydraulic mining in the California Gold Rush. While generating millions of dollars in tax revenues for the state and supporting a large population of miners in the mountains, hydraulic mining had a devastating effect on riparian natural environment and agricultural systems in California. Millions of tons of earth and water were delivered to mountain streams that fed rivers flowing into the Sacramento Valley. Once the rivers reached the relatively flat valley, the water slowed, the rivers widened, and the sediment was deposited in the floodplains and river beds causing them to rise, shift to new channels, and overflow their banks, causing major flooding, especially during the spring melt. Cities and towns in the Sacramento Valley experienced an increasing number of devastating floods, while the rising riverbeds made navigation on the rivers increasingly difficult. Perhaps no other city experienced the boon and the bane of gold mining as much as Marysville. Situated at the confluence of the Yuba and Feather rivers, Marysville was the final 'jumping off' point for miners heading to the northern foothills to seek their fortune. Steamboats from San Francisco, carrying miners and supplies, navigated up the Sacramento River, then the Feather River to Marysville where they would unload their passengers and cargo. Marysville eventually constructed a complex levee system to protect the city from floods and sediment. Hydraulic mining greatly exacerbated the problem of flooding in Marysville and shoaled the waters of the Feather River so severely that few steamboats could navigate from Sacramento to the Marysville docks. The sediment left by such efforts were reprocessed by mining dredges at the Yuba Goldfields, located near Marysville.