Interfacial reactions in molten state micro solder joints under current stressing

2018 
Abstract The high local temperature in flip-chip solder joints of microprocessors has raised concerns that the solder, a low melting temperature alloy, might locally liquefy and consequently cause failure of the micro solder joint. This article reports the electromigration (EM) behavior when the solder is in the molten state. The electronic current was applied to the Cu/Sn-3.0Ag-0.5Cu (SAC305)/Cu molten solder joints. The growth of the intermetallic compound (IMC) and the consumption of the Cu pad were investigated. Moreover, the transition of IMC 3-D morphologies was also studied by the deep-etching method after EM test. The results of the electromigration in the molten solder joints indicate that the growth of the interface IMC and the consumption of the Cu pad present similar trends with those in the solid state micro solder joints, however, the rates of the growth and consumption are higher than those in the solid state micro solder joints. The evolution of IMC 3-D morphologies during the electromigration in the molten solder joints shows its own unique features, which are different from the electromigration in the solid state solder joints. With the increase of stressing time, the IMC 3-D morphologies transition indicates that the average grain size of cathodic Cu 6 Sn 5 increases in radial direction with the increase of stressing time, but the size first increases, and then decreases in axial direction. In contrast to the morphologies transition for cathodic Cu 6 Sn 5 , the average grain size of anode Cu 6 Sn 5 increases not only in radial direction but also in axial direction.
    • Correction
    • Source
    • Cite
    • Save
    • Machine Reading By IdeaReader
    18
    References
    3
    Citations
    NaN
    KQI
    []