Film/substrate interactions and superconducting properties of Tl(Ba 1−x Sr x ) 2 Ca 2 Cu 3 O y thin films on (001) SrTiO 3 and SrTiO 3 -buffered (001) MgO substrates

We have developed a process for the fabrication of (001) oriented SrTiO3 buffer layers onto (001) MgO substrates by rf magnetron sputtering followed by a post-deposition heat treatment in air. Precursor films with Tl :Ba : Ca : Cu ratio 2 : 2 : 2 : 3 were deposited by dc magnetron sputtering onto both these buffered substrates and directly onto (001) SrTiO3 single-crystal substrates, and thalliated at elevated temperatures. Because of Sr diffusion from the substrate/buffer layer, and its subsequent substitution for Ba in the superconducting film, the single Tl–O layer phase Tl(Ba1−xSrx)2Ca2Cu3Oy was stabilized. Diffusion of Ba and Ca in the opposite direction led to the formation of a Ba–Ca–Ti–O compound at the interface. The Tl(Ba1xSrx)2Ca2Cu3Oy films typically have superconducting transition temperatures (Tc's) > 103 K and critical current densities (Jc's) > 2.9 × 105 A cm−2 at 77 K. Rs values measured on these films and scaled to 10 GHz were 3.0 mΩ at 80 K and <200 µΩ at 50 K for the film grown on SrTiO3 buffered MgO, and 2.0 mΩ and 1.0 mΩ at 50 K for the film grown directly onto the (001) SrTiO3 substrate. Films fabricated on (001) SrTiO3 using an in situ deposition technique with a substrate temperature around 100 °C lower than the ex situ thalliation temperature showed no evidence of an interfacial reaction layer.