B4C Particles Reinforced Al2024 Composites via Mechanical Milling

The control of a homogeneous distribution of the reinforcing phase in aluminum matrix composites is the main issue during the synthesis of this kind of material. In this work, 2024 aluminum matrix composites reinforced with boron carbide were produced by mechanical milling, using 1 and 2 h of milling. After milling, powdered samples were cold consolidated, sintered and T6 heat treated. The morphology and microstructure of Al2024/B4C composites were investigated by scanning electron microscopy; analysis of X-ray diffraction peaks were used for the calculation of the crystallite size and microstrains by the Williamson–Hall method. The mechanical properties were evaluated by compression and hardness tests. B4C particles were found to be well dispersed into the aluminum matrix as a result of the high-energy milling process. The crystallite size of composites milled for 2 h was lower than those milled for 1 h. The hardness, yield strength and maximum strength were significantly improved in the composites processed for 2 h, in comparison to those processed for 1 h and the monolithic 2024 alloy.