The Effect Of Increasing Femoral Head Size On The Force Required For Dislocation.

: Alternative bearings allow for the increased utilization of large femoral heads in total hip arthroplasty. This study demonstrated the effect of increasing femoral head size on the force required for dislocation during intraoperative assessment. Using a standard posterior approach, 10 cadaver hips underwent total hip arthroplasty; components were implanted in a standard fashion. The extremity was attached to a custom jig to replicate intraoperative assessment (internal rotation with 90° of hip flexion/neutral adduction). This range of motion (ROM) was repeated in triplicate using femoral head sizes of 28mm, 32mm, 36mm, 40mm, and 44mm. The ROM to dislocation (degrees) and torque (N*m) required were recorded. With increasing head sizes, there was a significant increase in torque required for dislocation (p<0.0001). The least square means torques (N*m) for each femoral head size (28-44mm) were 2.07, 2.15, 2.42, 2.74, and 3.65N*m. The corresponding least square means ROMs prior to dislocation were 43.5°, 46.2°, 50.8°, 54.3°, and 59.5°. There was a significant difference in ROM between nonadjacent head sizes (i.e., 28mm and 44mm) (p<0.0001). Total hip implant stability is multifactorial. Increasing femoral head size may confer stability during intraoperative assessment by increasing both the ROM prior to dislocation and the force required for dislocation.