Entwicklung eines Standard-Prüfverfahrens für Geräte zur thermischen Unkraut- bekämpfung Development of a standard test procedure for devices on thermal weed control

In contrast to the standard evaluation of the efficacy of pesticides and the testing of spraying equipment there are no comparable testing procedure for equipment of thermal weed control. It is the aim of the investigations described here to develop a standard procedure for assessing temperature distribution and biological efficacy. This will be the basis for quality testing which can be directly used by practical users. Also it can help engineers to improve devices if constructive gaps will be identified by these tests. The results from testing a flaming device (Green-Flame 850 E) demonstrated such a potential for technical improvement: The temperature decreased from 159 °C to 89 °C by increasing driving speed from 0.35 m/s to 0.81 m/s. The variation of the temperature related to the working width was extremely high: The range was 60 °C at highest speed and 79 °C at lowest speed, respectively. The biological efficacy against the test plant species Sinapis arvensis was also affected by the driving speed and the corresponding temperature. A driving speed not higher than 0.53 m/s resulted in efficacy rates of almost 95%. However, the efficacy was only 66% at the highest tested speed of 0.81 m/s. Thus, the needed effective temperature is between 89 °C und 106 °C. In contrast, Lolium perenne was controlled by only 72% under the tested conditions. Here a dose-response relationship was not observed. The variation of the temperature, as well as the biological efficacy, was extremely heterogeneous and not satisfying in terms of an economic and safe use. Similar results were found for other devices on thermal weed control.