Correction of the measured current of a small-gap plane-parallel ionization chamber in proton beams in the presence of charge multiplication.

Abstract Purpose The aims of this work are to study the response of a small-gap plane-parallel ionization chamber in the presence of charge multiplication and suggest an experimental method to determine the product of the recombination correction factor (ks) and the charge multiplication correction factor (kCM) in order to investigate the latter. Methods Experimental data were acquired in scanned proton beams and in a Cobalt-60 beam. Measurements were carried out using an IBA PPC05 chambers of which the electrode gap is 0.6 mm. The study is based on the determination of Jaffe plots by operating the chambers at different voltages. Experimental results are compared to theoretical equations describing initial and volume recombination as well as charge multiplication for continuous and pulsed beams. Results Results obtained in protons and Cobalt-60 with the same PPC05 chamber indicate that the charge multiplication effect is independent of the beam quality, while results obtained in different proton beams with two different PPC05 chambers show that the charge multiplication effect is chamber dependent. Conclusions The approach to be taken when using a small-gap plane-parallel ionization chamber with a high voltage (e.g. 300 V or 500 V) for reference dosimetry in scanned proton beams depends on which correction factors were applied to the chamber response during its calibration in terms of absorbed dose to water: - if ks and kCM are applied during the calibration, the user can use a linear extrapolation method (e.g. two-voltage method or 3VL-method) to determine the product of ks and kCM in the user beam. - if ks and kCM are not applied during the calibration: the user can neglect kCM and determine ks in the user beams using a linear interpolation of the chamber response. In both cases, it is recommended to use the ionization chamber at the same operating voltage used during its ND,w-calibration. Another solution consists of operating the PPC05 chamber at a lower voltage (e.g. 50 V) with larger ks and smaller kCM and determining the product of both factors with higher accuracy using a linear extrapolation method.