Preparation and in vitro release evaluation of slow releasing intrauterine silicone rubber bar made of Panax notoginseng and Rubia cordifolia

: To prepare the intrauterine slow release silicone rubber bar made of Panax notoginseng and Rubia cordifolia, and finish its preliminary evaluation of in vitro releasing properties. The open mill method was used for plasticating of silicone rubber. The process parameters of the silicone rubber and drugs mixing were optimized by orthogonal test. The parameters of silicone rubber vulcanization was optimized by single factor test. The preliminary evaluation of in vitro release performance of the silicone rubber bar was conducted with ginsenoside Rg₁, ginsenoside Rb₁, notoginsenoside R₁, purpurin and rubimaillin as the indexes. The results showed that optimum technologic parameters for silicone rubber and drugs mixing：the roller spacing 2 mm; speed ratio 1∶1.2; front roller temperature 55-60 ℃; rear roll temperature 50-55 ℃; and mixing time 20 min. The optimum parameters for silicone rubber vulcanization：temperature 90 ℃, and time 60 min. The studies on release process in vitro revealed that the release process of silicone rubber bar was in line with the Higuchi equations. After 90 days, the cumulative release of ginsenoside Rg₁, ginsenoside Rb₁ and notoginsenoside R₁ was 46.7%, and the cumulative release of purpurin and rubimaillin was 51.9%. The preparation method can be applied to the preparation of silicone rubber bar, with slow release characteristics.