Measurements of electron density profile by frequency modulated continuous wave reflectometer in the T-10 tokamak using high magnetic field side probing and extraordinary mode lower cutoff

A new, previously unused combination of the high magnetic field side probing and the lower extraordinary mode cutoff was used in the T-10 tokamak for the electron density profile measurements by using a frequency modulation continuous wave reflectometer. This scheme has a significant advantage for large fusion machines where flat electron density profiles and high electron temperatures are expected. The reflectometer design is based on a common scheme with voltage controlled oscillators, active multipliers, and in-phase/quadrature signal detection. Iterative procedures were applied to calibrate a microwave source frequency and compensate the dispersion of probing signals in the conventional rectangular waveguides used as the transmission lines. About 0.2% stability of the beating frequency was reached after the calibration procedure had been finished. An advanced finite-difference scheme was proposed for the reconstruction of the electron density profile to reduce errors and improve the overall performanc...