Effect of SiC powder on the properties of SiC Slurry for Stereolithography

Abstract Silicon carbide (SiC) is a kind of structural ceramics with excellent properties and it is widely used in industrial fields. Stereolithography (SL) is a potential additive manufacturing technique to fabricate fine complex SiC components, the resin-based SiC slurry with superior rheological and photo-polymerization properties is important for SL. In this paper, we investigated the influence of SiC powder on the properties of the SiC slurries for SL. The physical characteristics of SiC powder such as particle size, size distribution and appearance were tested and observed, and their influence on the dispersion, sedimentation and photo-polymerization property of the SiC slurry were investigated and discussed in detail based on their correlative theory, we finally prepared SiC slurry with superior rheological and photo-polymerization properties, and fabricated the fine complex SiC green body with low defects, high accuracy and high bending strength successfully. The SiC slurry with the solid content of 40 vol.% was fabricated by the SiC powder with the median diameter D50≈ 10.0 μm and a narrow particle size distribution, it is Bingham fluid with good fluidity and the viscosity of it is 464.40 mPa.s under the shear rate of 51.08 s-1, the cured SiC parts with Z – axis dimension change of 0.75 % was finally fabricated, the three points bending strength of it is 50.18 MPa. Our research work provides some fundamental understanding of the SL technique for fabricating fine complex SiC components, explored a suitable way to fabricate high quality SiC green parts through SL, and offers some valuable references for preparing SiC slurry with superior rheological and photo-polymerization properties.