In vitro investigation of the influence of printing direction on the flexural strength, flexural modulus and fractographic analysis of 3D-printed temporary materials

The aim of this in vitro study was to evaluate the effect of printing direction and aging on the mechanical strength of 3D-printed temporary resin-based composites. Three hundred and sixty specimens (2×2×25 mm³) out of three materials were DLP printed. Specimens were either stored in distilled water for 24 h at 37°C or additionally subjected to thermocycling. Flexural strength (FS) and flexural modulus (FM) were evaluated in a three-point bending test considering three printing directions. Fractography was carried out by light microscopy, surfaces were categorized according to fracture origin. FS ranged from 93.2 to 159.9 MPa and 76.8 to 135.1 MPa in nonaged and aged specimens in the material sequence: Freeprint temp

Keywords:

• 3d printed
• in vitro study
• Materials science
• Composite material
• Bending
• Flexural modulus
• Flexural strength
• mechanical strength
• Fractography
• Distilled water

• Correction
• Source
• Cite
• Save
• Machine Reading By IdeaReader