Design, Manufacture, and Performance Testing of Extrusion–Pultrusion Machine for Fiber-Reinforced Thermoplastic Pellet Production

2021 
This study aimed to develop an extrusion and pultrusion system for producing carbon fiber-filled thermoplastic pellets. The extruder delivers a plastic melt to an impregnation die in sufficient volume and is pulled out along with the fibers. The fibers pass in a sideways stretched condition through spreader pins attached in the melt pool, which can then be wetted optimally. The wetting effect was also improved by immersing fiber in a coupling agent solution at an elevated temperature before feeding to the extruder die. For machine performance testing, polypropylene was used as a matrix resin with the following parameters: a screw speed of 5 rpm, a die temperature of 210 °C, and a pulling speed of 56 mm/s. The pull-out test was conducted to assess the interfacial shear strength (IFSS) between fibers and matrix. Scanning electron microscopy (SEM) was applied to characterize the quality of fiber impregnation. SEM characterized a good bonding performance between carbon fiber and the matrix. The average IFSS of the results indicated a good resistance of fiber–matrix bonding against a pulling force. It proved that the combination of the extrusion–pultrusion system can produce high-quality filaments as a raw material of composite pellets.
    • Correction
    • Source
    • Cite
    • Save
    • Machine Reading By IdeaReader
    22
    References
    0
    Citations
    NaN
    KQI
    []