Signalfel – Hur kan dessa reduceras? : Analys av driftstörningar i signalsystem på Ostkustbanan

During the past decades, the railway train delays have increased greatly associated with a decreasing reliability. The cause of the low reliability can be connected to the increased amount of traffic and the lagging maintenance, that is to say worn track that remains too long. This thereby increases sensitivity to disturbance of the fault that causes stop in the traffic, usually termed it as a 'signal failure'.A signal failure is an error that can occur in a variety of components within the signalling system. These have been divided into six different parts consisting of signalling control, track circuits, beacons, train control systems, level crossings and signals themselves. An error in one of its components gives the result that the signals go to a safe state, which means a halt in traffic.The causes and components that contribute to a low reliability of the railways are highlighted in this work to raise awareness of the problems found in the railway. The focus has been on developing action proposals on the component that is deemed most sensitive in the signaling system.The results showed that errors occurring in the signaling system are mostly generated by the track circuits. The most common error in track circuits is the occurrence of conduction on the insulated joints, which is judged as the most sensitive component in the signalling system. This is especially true in the Stockholm area, which is where the train traffic is as most dense and where disturbances affect a large number of travelers.Actions performed on track circuit faults are mainly short-term solutions such as cleansing, checks and no actions at all. Solutions usually performs after error has occurred, which means that signalling failure and its consequences already has affected the traffic. In order to increase the reliability it requires a more active and effective maintenance work. Investments in innovative solutions and action proposals should be performed in order to reduce the frequency of disturbances.