Experimental measurement of energy release from an initiating layer in an insensitive explosive

Abstract When subjected to a shock of insufficient strength to trigger prompt reaction, heterogenous condensed phase explosives can form regions where significant amounts of the explosive remain unreacted for times much greater than the reaction time of the detonating explosive. This phenomena is observed for the explosive PBX 9502 (95 wt% TATB) both for planar and oblique input shocks. In this work, we build on previous results by performing cylinder expansion (CYLEX) tests where the explosive charge is comprised of a faster core of PBX 9501 (95 wt% HMX) inside a slower annulus of PBX 9502. The detonation in the faster PBX 9501 drives an oblique shock into the adjacent PBX 9502, and an annular transverse initiating layer (IL) results. In the test geometry, the IL travels steadily down the length of the test after a short run distance. At radial positions beyond the IL, an annular region of detonating PBX 9502 is observed. Using standard CYLEX test diagnostics, we infer the total energy release of this experiment. By making the assumptions that (1) the combined energy release is comprised of contributions from detonating PBX 9501, detonating PBX 9502, and the IL in the PBX 9502 and (2) mass-specific energy release for the detonating explosives is approximately the same as typically observed for each explosive, the IL energy release and reaction efficiency can be computed. Results are compared to prior results for a similar geometry, and indicate that while shock deadened PBX 9502 does not detonate promptly, it does eventually release a significant portion of its chemical potential energy over longer timescales on the order of 10 µs.