Deep dry-etch of silica in a helicon plasma etcher for optical waveguide fabrication

Dry-etch of SiO2 layers using a CF4 plasma in a helicon plasma etcher for optical waveguide fabrication has been studied. Al2O3 thin films, instead of the conventional materials, such as Cr or photoresist, were employed as the masking materials. The Al2O3 mask layer was obtained by periodically oxidizing the surface of an Al mask in an oxygen plasma during the breaks of the SiO2 etching process. A relatively high SiO2/Al2O3 etching selectivity of ∼100:1, compared with a SiO2/Al selectivity of ∼15:1, was achieved under certain plasma condition. Such a high etching selectivity greatly reduced the required Al mask thickness from over 500 nm down to ∼100nm for etching over 5-μm-thick silica, which make it very easy to obtain the mask patterns with near vertical and very smooth sidewalls. Accordingly, silica wavegudies with vertical sidewalls whose roughness was as low as 10 nm were achieved. In addition, the mechanism of the profile transformation from a mask to the etched waveguide was analyzed numerically; ...