Intraplate stress field in South America from earthquake focal mechanisms

Abstract We present an updated compilation of earthquake focal mechanisms in Brazil together with focal mechanisms from the sub-Andean region (mainly from global CMT catalogs). All earthquakes in the sub-Andean region show reverse (majority) or strike-slip faulting mechanisms. Focal mechanisms in Brazil show reverse, strike-slip and normal faulting. Focal mechanisms of nearby earthquakes in the same tectonic environment were grouped and inverted for the stress tensor. In the sub-Andean region, stresses are compressional, as expected, with the principal major compression (S1) roughly E-W, on average. A slight rotation of S1 can be observed and is controlled by the orientation of the Andean plateau. In the sub-Andean region, the intermediate principal stress (S2) is also compressional (i.e., larger than the lithostatic pressure, Sv), a feature that is not always reproduced in numerical models published in the literature. In mid-plate South America stresses seem to vary in nature and orientation. In SE Brazil and the Chaco-Pantanal basins, S1 tends to be oriented roughly E-W with S2 approximately equal to S3. This stress pattern changes to purely compressional (both SHmax and Shmin larger than Sv) in the Sao Francisco craton. A rotation of SHmax from E-W to SE-NW is suggested towards the Amazon region. Along the Atlantic margin, the regional stresses are very much affected by coastal effects (due to continent/ocean spreading stresses as well as flexural effects from sediment load at the continental margin). This coastal effect tends to make SHmax parallel to the coastline and Shmin (usually S3) perpendicular to the coastline. Few breakout data and in-situ measurements are available in Brazil and are generally consistent with the pattern derived from the earthquake focal mechanisms. Although numerical models of global lithospheric stresses tend to reproduce the main large-scale features in most mid-plate areas, the S1 rotation from ∼E-W in SE Brazil to SE-NW in the Amazon region are not well explained by the current numerical models. This means that the observed stress pattern in mid-plate South America should provide new insights into upper mantle dynamics, distinct from current global convection models.