Design and Calibration of Moisture Sensor Based on Electromagnetic Field Measurement for Irrigation Monitoring

Soil moisture control is crucial to assess irrigation efficiency in green areas and agriculture. In this paper, we propose the design and calibration of a sensor based on inductive coils and electromagnetic fields. The proposed prototypes should meet a series of requirements such as low power consumption, low relative error, and a high voltage difference between the minimum and maximum moisture. We tested different prototypes based on two copper coils divided into two different sets (P1–P15 and NP1–NP4). The prototypes have different characteristics: variations in the number and distribution of spires, existence or absence of casing, and copper wires with a diameter of 0.4 or 0.6 mm. In the first set of experiments carried out in commercial soil, the results showed that the best prototypes were P5, P8, and P9. These prototypes were used in different types of soils, and P8 was selected for the subsequent tests. We carried the second set of experiments using soil from an agricultural field. Based on the data gathered, mathematical models for the calibration of prototypes were obtained and verified. In some cases, two equations were used for different moisture intervals in a single prototype. According to the verification results, NP2 is the best prototype for monitoring the moisture in agricultural lands. It presented a difference in induced voltage of 1.8 V, at 500 kHz, between wet and dry soil with a maximum voltage of 5.12 V. The verification of the calibration determined that the calibration using two mathematical models offers better results, with an average absolute error of 2.1% of moisture.