Reflection imaging with earthquake sources and dense arrays

The Mw 5.8 earthquake that occurred in Louisa County, Virginia, on 23 August 2011 provided an opportunity to record with several “high density” seismic arrays, in addition to traditional, sparse temporary seismic networks. Traditional aftershock networks consist of a few dozen stations spread over tens of kilometers. As a result, the recorded seismic waveforms suffer from spatial aliasing that is so severe that many types of waveform processing are not applicable. Here we report the results of recording with a large number of oil industry-type instruments deployed at a spacing that is an order of magnitude closer than in traditional deployments. The objective was to image subsurface structure with array methods, using the aftershocks as sources. The dense array recorded continuously for 12 days and consisted of 172 vertical component seismometers that were placed at 200–400 m and a 60 km long three-component regional profile with stations every 2 km. We demonstrate how processing techniques from Vertical Seismic Profiling can produce high-resolution 3-D reflection images of structure beneath the array. These images display reflectivity that correlates with that observed on a nearby deep reflection survey collected by the U.S. Geological Survey. Of particular interest is a strong reflector imaged across multiple profiles. Our analysis demonstrates how a surface array of seismometers can provide 3-D images of structure using microearthquake sources when wavefields are sampled sufficiently densely.