Modified iterative approach for predicting machined surface topography in ball-end milling operation

Machined surface topography prediction is an important and useful tool for optimizing cutting parameters. However, accurate prediction of machined surface topography in ball-end milling operation has been extremely challenging, due to the complexity in tool-workpiece interaction induced by the trochoidal motion of cutting edge and computing burden. In this present research, a modified iterative approach was proposed to solve the intersections between the cutting-edge sweeping surface and the discrete Z-vector model of workpiece, which were used to predict the machined surface topography in ball-end milling operation. Firstly, the accurate model of cutting-edge sweeping surface was established utilizing homogeneous coordinate transformation, in which the tool runout was considered. Secondly, the cutting-edge sweeping surface was dispersed into a series of patches in accordance with equal parameter interval, and the in-cut patch was extracted by using the minimum and maximum axial immersion angle of the cutting edge. Thirdly, the intersection between each in-cut patch and discrete Z-vector was solved using the Newton’s method, which was used to update the endpoint of the corresponding discrete Z-vector. Finally, ball-end milling experiments of AISI P20 steel were carried out to validate the proposed approach as well as investigate the effect of cutting parameters on the machined surface topography and roughness. The predicted machined surface topography and roughness were in good agreement with the measured results. Moreover, the proposed approach needs less computing time than the traditional iterative approaches at the same predicting accuracy. This research also provides guidance for optimizing cutting parameters to control surface quality in ball-end milling operation.