EUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH European Laboratory for Particle Physics

A cryogenic thermometer calibration facility has been designed and is being commissioned in preparation for the very stringent requirements on the temperature control of the LHC superconducting magnets. The temperature is traceable in the 1.5 to 30 K range to standards maintained in a national metrological laboratory by using a set of RhodiumIron temperature sensors of metrological quality. The calibration facility is designed for calibrating simultaneously 60 industrial cryogenic thermometers in the 1.5 K to 300 K temperature range, a thermometer being a device that includes both a temperature sensor and the wires heat-intercept. The thermometers can be calibrated in good and degraded vacuum or immersed in the surrounding fluid and at different Joule self-heating conditions that match those imposed by signal conditioners used in large cryogenic machinery. The calibration facility can be operated in an automatic mode and all the control and safety routines are handled by a Programmable Logic Controller (PLC). LabVIEW ® is used both as the PLC operator interface and for configuring and reading the thermometric data sampled by the higher accuracy laboratory equipment. The isothermal support onto which the thermometers are mounted is thermally anchored through the wiring to a helium bath. The calibration procedure begins once the temperature of the support is stabilized. Measured data is presented and it is possible to infer that the absolute accuracy that can be obtained is better than ∠ 5 mK for the full temperature range.