A hybrid system using Brayton cycle to harvest the waste heat from a direct carbon solid oxide fuel cell

Abstract A new hybrid system model is developed to evaluate the potentials of a Brayton cycle heat engine for waste heat recovery from a direct carbon solid oxide fuel cell (DC-SOFC). The maximum power density of the proposed system is up to 0.8675 Wcm -2 , which is approximately 1.8 times as large as that of the single DC-SOFC. Numerical calculations also indicate that the proposed hybrid system is an efficient approach to boost the fuel utilization, and the maximum power density of the proposed system is markedly better than that of the DC-SOFC/thermophotovoltaic cell, DC-SOFC/thermionic generator, and DC-SOFC/Otto heat engine hybrid systems except for the DC-SOFC/Stirling engine hybrid system. The optimum regions for power density, efficiency and operating current density of the proposed system are determined. The higher operating temperature and lower gap between the anode and carbon layer increase the power density and efficiency of the proposed system. Moreover, the higher heat transfer coefficient boosts the power density and efficiency at high current density. The compression efficiency, expansion efficiency and recuperator coefficient significantly affect the power density and efficiency.