MC3T3-E1 cell response to microporous tantalum oxide surfaces enriched with Ca, P and Mg

2021 
Abstract The formation of a porous oxide surface doped with osteoconductive elements, Ca, P and Mg, to enhance osseointegration, was achieved through micro arc oxidation. Micro arc oxidation parameters, such as electrolyte composition, concentration and applied voltage, were studied to understand their effect on the morphology and chemical composition of the samples surface. Considering the optimum atomic concentration reported in literature for each osteoconductive element, microporous Ta anodic oxide samples treated with calcium acetate (CaA) and β-glycerophosphate (β-GP) revealed that an increase of β-GP molarity in the electrolyte boosts Ca incorporation, as well as, increasing the porosity. In adding magnesium acetate (MgA) to the electrolyte, when composed by CaA + β-GP, both addition and variation of MgA did not affect the surface morphology along the samples, being incorporated into the oxide layer for 0.1 M. Finally, in vitro tests were carried out to study the biocompatibility of Ta, to verify the cytotoxicity of the samples and their behavior towards cells, by performing adhesion and differentiation tests with the MC3T3-E1 cell line. Cytotoxicity tests revealed that the samples were non-toxic. Despite none of the samples having been raised up through cell adhesion tests, cell differentiation revealed promising results for the Ta-CaP.
    • Correction
    • Source
    • Cite
    • Save
    • Machine Reading By IdeaReader
    56
    References
    2
    Citations
    NaN
    KQI
    []