Corrigendum to Durability of symmetric-structured metal-supported solid oxide fuel cells [J. Power Sources 369 (2017) 6–12]

The authors regret that a technical mistake has been discovered, which impacts the current density and power density reported in this article. Briefly, the mistake was caused by catalyst solution leaking out of the intended 1 cm catalyzed area and depositing catalyst over the whole cell. As a result, the calculated current and power densities (total divided by the catalyzed area) were higher than reality because the measured current and power were dividing by the intended 1 cm instead of the actual area including the leakage, which was approximately 5 cm . This issue is presented, analysed, and discussed in further detail in the supporting information of Reference [1]. The authors would like to apologise for any inconvenience caused. 2 2 2