Specimen-specific fracture risk curves of lumbar vertebrae under dynamic axial compression.

Abstract Underbody blast attacks of military vehicles by improvised explosives have resulted in high incidence of lumbar spine fractures below the thorocolumbar junction in military combatants. Fracture risk curves related to vertical loading at individual lumbar spinal levels can be used to assess the protective ability of new injury mitigation equipment. The objectives of this study were to derive fracture risk curves for the lumbar spine under high rate compression and identify how specimen-specific attributes and lumbar spinal level may influence fracture risk. In this study, we tested a sample of three-vertebra specimens encompassing all spinal levels between T12 to S1 in high-rate axial compression. Each specimen was tested with a non-injurious load, followed by a compressive force sufficient to induce vertebral body fracture. During testing, bone fracture was identified using measurements from acoustic emission sensors and changes in load cell readings. Following testing, the fractures were assessed using computed tomographic (CT) imaging. The CT images showed isolated fractures of trabecular bone, or fractures involving both cortical and trabecular bone. Results from the compressive force measurements in conjunction with a survival analysis demonstrated that the compressive force corresponding to fracture increased inferiorly as a function of lumbar spinal level. The axial rigidity (EA) measured at the mid-plane of the centre vertebra or the volumetric bone mineral density (vBMD) of the vertebral body trabecular bone most greatly influenced fracture risk. By including these covariates in the fracture risk curves, no other variables significantly affected fracture risk, including the lumbar spinal level. The fracture risk curves presented in this study may be used to assess the risk of injury at individual lumbar vertebra when exposed to dynamic axial compression.