Optimizing weld morphology and mechanical properties of laser welded Al-Si coated 22MnB5 by surface application of colloidal graphite

Abstract In the automotive industry, the demand for reduced vehicle weight, improved safety and enhanced crashworthiness qualities continues to rise which introduces the need for parts with tailored properties. This demand can be met by employing tailor-welded blanks which are made of two or more types of press-hardened steels that are laser welded together and then hot-stamped to produce highly optimized parts for use in vehicle body-in-white applications. The most commonly used press-hardened steel for high strength applications is the Al-Si coated 22MnB5 grade steel that has a strength of around 1500 MPa in the hot-stamped condition. Although the Al-Si coating offers excellent barrier protection against oxidation and decarburization during hot-stamping, the Al-Si coating proves to be problematic during laser welding as it melts and mixes into the weld pool increasing the Al-content in the fusion zone, which promotes the formation of ferrite during the heat-treatment stage of hot-stamping, resulting in a dual-phase fusion zone microstructure that consists of ferrite grains embedded in a martensitic matrix. The presence of the softer ferrite phase has been shown to be the principal reason for premature failure of hot-stamped laser-welded joints. Currently, this issue is resolved by an additional, and relatively costly, manufacturing step that involves the laser ablation of the Al-Si coating prior to welding. The present work shows that this step can be eliminated from the manufacturing process by welding Al-Si coated 22MnB5 steel through a colloidal graphite coating which results in the in-situ ablation of the Al-Si coating during welding. This changes the alloying chemistry of the fusion zone which affects the resulting morphology by preventing ferrite formation which improves the mechanical properties of the weld. Failure in these welded samples was successfully shifted from the fusion zone, where it normally occurs, to the base material.