Swelling pressure of compacted MX80 bentonite/sand mixture prepared by different methods

Abstract Compacted bentonite/sand mixture have been considered as possible sealing/backfilling material in the deep geological disposal of high-level radioactive nuclear waste. The swelling pressure of the compacted bentonite/sand mixture is of significance in the design of the geological repository, which requires good consistency between data obtained by laboratory and field measurement. In this work, a series of swelling pressure tests were performed on compacted MX80 bentonite/sand specimens prepared by methods commonly adopted in laboratory (As-compacted, Transferred) and those mimicking the real block manufacturing process (Trimmed, Inserted). Results shown that with identical dry density (especially when the dry density was larger than 1.70 Mg/m3), largest swelling pressure was obtained in specimens prepared by method Inserted, followed by method As-compacted, Transferred and Trimmed. The distinct difference between the swelling pressure could be largely attributed to the effects of residual post-compaction lateral stress. More interestingly, specimens prepared by methods Trimmed and Transferred followed a similar swelling pressure-dry density relationship. From this point of view, method Transferred without causing mass loss, change of bentonite content and possible technological voids effect was recommended in lieu of method Trimmed for specimen preparation in laboratory.