Introduction of flat ribbon cable (FRC) sensor for density measurement of road materials using time domain reflectometry (TDR)

Moisture content and density of unbound granular pavement materials are important properties for compaction control providing a great influence on pavement performance. Time domain reflectometry (TDR) usually uses rod probe sensors, which can provide pointwise readings of density. However, pointwise readings might not be representative enough for a complete road section. This paper introduces the application of flat ribbon cable (FRC) sensor, which can be extended up to 6 meter to measure moisture and density of road materials. Soil specific calibration is done in the laboratory considering the variation of moisture and density of materials where sensors of three different lengths are considered to enable the development of length normalized calibration. The electric parameter used to derive soil density is the voltage drop, which occurs after the passage of an electromagnetic wave along the sensor embedded in the soil. Soil moisture is related to the permittivity of the soil sample, which is obtained from the travel time of the TDR signal. Laboratory results indicate that calibration functions are independent of moisture and density. These soil specific calibration functions are useful in measuring long term pavement performance and managing rutting of roads.