Detection of thrombosis in a magnetically levitated blood pump by vibrational excitation of the impeller

The use of contactless support technology for the impeller has led to an increase in the durability of ventricular assist devices (VADs), and these have been in clinical use worldwide. However, pump thrombosis and stroke are still issues to be solved. We have developed a method for detecting the thrombosis in a magnetically levitated blood pump without the need for additional sensors or other equipment. In the proposed method, a sinusoidal current is applied to the electromagnets used for the magnetic bearing, resulting in vibration of the impeller. The phase difference between the current and displacement of the impeller increases with pump thrombosis. First, we describe the principle by which the pump thrombosis is detected. Pump thrombosis reduces the narrowest fluid gap in the pump and this gives rise to a change in the phase difference. Second, we report on experiments in which we changed the narrowest fluid gap using oriented polypropylene tape and showed that decreasing the narrowest fluid gap resulted in an increase in phase difference. For these experiments, the measurements were repeated three times for each condition. Third, we examine the relationship between the pump thrombosis and the phase difference evaluated by observations of the underside of the impeller when operating the pump with porcine blood. Since light was unable to penetrate the blood layer, the erythrocytes were removed for this observation. Only one observation was made. The results showed the phase difference rapidly increased at the same moment when the pump thrombosis was observed. This implies the proposed method has the potential to detect the early stages of pump thrombosis. Finally, in vitro experiments to detect thrombosis when using whole porcine blood in the pump were conducted. The experiment was carried out five times. To intentionally form a thrombus inside the pump, the activated clotting time was controlled to be less than 200 s. In every case, the phase difference increased by more than one degree after tens of minutes. Then, the pump was disassembled and a small amount of pump thrombosis was observed. We conclude that real-time diagnosis of pump thrombosis may be realized by measuring the phase difference without the need for additional sensors.