A tomographic glimpse of the upper mantle source of magmas of the Jemez lineament, New Mexico

The 800-km-long Jemez lineament is the most active volcanic feature in the southwestern United States. It is the southeastern tectonic boundary of the Colorado Plateau and crosses the Rio Grande rift at the Jemez Mountains. The primary volcanism of the lineament is basaltic and has occurred in the last 4.5 m.y. To infer spatial distributions of partial melt in the upper mantle source zones for the Rio Grande rift and the Jemez lineament, we investigated the lateral variations of P wave velocity in the upper mantle beneath these features. We used teleseismic P wave delays recorded at a 22-station network to perform a damped least squares, three-dimensional inversion for these lateral variations. Our technique employed velocity interpolation within a three-dimensional grid of points, rather than using blocks of constant P wave velocity. This method allows highly realistic computation of seismic ray paths as well as accurate computation of the matrix elements in our system of equations. Determinations of resolution of results were done in two independent ways, both of which gave consistent estimates of resolution. In our best resolved volume the inversion showed no significant concentration of relative low velocity for P waves beneath the Rio Grande rift. However, directly beneath the Jemez lineament there is a ∼100-km-wide, 1–2% low-velocity feature in the depth range of 50–160 km. Because of the association of the low P wave velocity with the Jemez volcanic lineament but not with the Rio Grande rift, because lowered P wave velocity can be associated with increased partial melt, and because the volume of recent volcanism at the lineament greatly exceeds that at the rift, we infer that a large magmatic source zone exists beneath the Jemez lineament but not beneath the Rio Grande rift. This implies that the volcanic potential of the Jemez lineaments continues to greatly exceed that of the Rio Grande rift. The mantle source zones for volcanics of the Jemez lineament are not overridden by, but rather track, the motion of the North American plate; this implies that these sources are within the lithospheric plate, as is clarified in the discussion. The magmatic source zones of the Jemez lineament are modeled as due to clockwise rotation of the Colorado Plateau about a pole in northeastern Colorado. This rotation caused extension of the lithosphere beneath the Jemez lineament, permitting concentration there of partially melted rock in the upper mantle.