Structure of the Rotor Tip Flow in a Highly Loaded Single-Stage Axial-Flow Pump Approaching Stall: Part II — Stall Inception — Understanding the Mechanism and Overcoming Its Negative Impacts

When reaching the stall point of an axial-flow pump, the pump head characteristic becomes unstable and the pump head suddenly drops. Before this happens however, at even higher flow rates the NPSH3 and the pump body and shaft vibrations increase dramatically. For effectively increasing the available operating range, it is essential to find a solution for all three problems without reducing the pump efficiency at design. The paper describes an experimental investigation on the outlined subject that gives insight into the flow phenomena leading to stall. Based on this knowledge a very simple type of casing treatment was chosen and investigated. It was found to satisfy all mentioned requirements. Subject to the investigations is a highly loaded axial-flow pump having a nq of 150 (SI units). The overall pump performance was investigated measuring pump head, efficiency, NPSH3, and casing as well as shaft vibrations. Further-more, oil flow pictures taken at the pump casing and at the rotor blades, and video captures of the cavitating core of the tip clearance vortex were analyzed for understanding the flow phenomena leading to stall (see also related paper Part I, Schrapp et al. (2004)). From the video captures it was realized that the behavior of the tip clearance vortex which was found to perform so-called spiral-type vortex breakdown is triggering stall inception in this machine.Copyright © 2004 by ASME