Toward more sustainable photovoltaic solar electrochemical oxidation treatments: Influence of hydraulic and electrical distribution.

Abstract Powering electrochemical technologies with renewable energies is a promising way to get more sustainable environmental remediation techniques. However, the operational conditions of those processes must be optimized to undergo fast and efficient treatments. In this work, the influence of electrical and hydraulic connections in the performance of a set of two electrolyzers directly powered by photovoltaic panels was evaluated. Despite both electrolyzers were assembled using the same electrode material, they showed different performances. Results indicate that the electrolyzer with higher ohmic resistance and higher overpotential attained a greater production of oxidant species, being produced under the most efficient strategy around 4.8 and 15.1 mmol of oxidants per Ah by electrolyzer 1 and 2, respectively. Nevertheless, an excess of oxidant production because of an inefficient energy management, led to low removal efficiencies as a consequence of a waste of energy into undesirable reactions. Regarding the hydraulic distribution of wastewater between the cells, it was found to influence on the total remediation attained, being the serial connection 2.5 and 1.8 more efficient than a parallel wastewater distribution under series and parallel electrical strategies, respectively. Regarding electrical strategies, parallel connections maximize the use of power produced by the photovoltaic panels. Furthermore, this allows the system to work under lower current densities, reducing the mass transfer limitations. Considering both advantages, a hydraulic connection of the cells in series and an electrical connection in parallel was found to reach the highest specific removal of pollutant, 2.52 mg clopyralid (Wh)-1. Conversely, the opposite strategy (parallel hydraulic connection-series electrical connection) showed the lowest remediation ratio, 0.48 mg clopyralid (Wh)-1. These results are important to be considered in the design of electrolytic treatments of waste directly powered by photovoltaic panels, because they show the way to optimize the cells stack layout in full-scale applications, exhibiting significant impact on the sustainability of the electrochemical application.